Full Exposed Fastener Overhaul & Neoprene Washer Sealing
Temperature swings of 60°F in 24 hours cause metal roof panels to expand and contract dramatically, backing out original factory screws. We remove degraded fasteners and install larger-gauge hot-dipped galvanized screws with vulcanized EPDM washers that seal against rain.
End-Lap Resealing with High-Solids Polyurethane Sealants
Horizontal panel end-laps on low-pitch roofs are notorious capillary leak points. We clean oxidized metal seams, apply industrial-grade butyl sealing tape between panel laps, and top-seal exterior joints with flexible UV-resistant polyurethane compounds.
Snow-Damaged Ridge Cap & Snow Retention Rail Replacement
Heavy snow slides descending mountain metal roofs can rip off ridge vents and tear plumbing vent pipes. We install reinforced heavy-gauge ridge caps and engineered bar-style snow retention systems anchored securely into underlying roof purlins.
Elastomeric Waterproof Coating for Aged Metal Surfaces
For oxidized or peeling metal roofs showing surface corrosion, we apply commercial rust-inhibiting primers followed by high-solids elastomeric silicone roof coatings, extending roof service life by 15+ years without panel replacement.
Frequently Asked Technical Questions
How often do exposed fasteners need to be replaced on a metal roof?
In Western NC mountain climates, exposed neoprene rubber washer screws typically need inspection and replacement every 10 to 15 years due to UV degradation and thermal cycling.
Can a leaking metal roof be repaired without replacing all panels?
Yes. Most metal roof leaks originate around backed-out fasteners, failed valley flashing, or dried-out ridge sealant. Targeted repairs reliably restore waterproof integrity at a fraction of re-roofing cost.
Why does my metal roof leak around the chimney when it rains hard?
Chimneys interrupt the continuous flow of metal panels. Leaks occur when mortar reglet counter-flashing cracks or when wide chimneys lack an engineered metal diversion cricket.